How to remove a front wheel drive manual transmission

Every vehicle is different, but here is a general overview of how you remove a drive axle on a front wheel drive vehicle (an independent rear axle is similar): The axle nut requires a large amount of torque to loosen, if possible break it free before raising the car. I need to remove the spindle from the hub of a kia spectra manual transmission front wheel drive. Mechanic's Assistant: The Kia Mechanic will be happy to explain that. Do you have any other details about the vehicle that could be helpful? Im .  · 2. Insert the new CV axle into the transmission housing. Just as you removed the old CV axle, insert the new one into the same spot in the transmission housing. The peg will slide all the way in until the axle is flush against the housing. There is a small C-clip on the axle that you will feel snap into www.doorway.ru: K.

As a vehicle is being driven, transmission fluid circulates throughout the transmission, cooling, lubricating and cleaning internal components. With the exception of some four-wheel-drive and all-wheel drive vehicles, a transmission must be in neutral if the vehicle is being towed on its drive wheels, such as being flat towed behind an RV. Because engine removal often means moving the engine forward as well as up, remove the radiator, A/C condenser and header panel at the front of the vehicle. For those with a van or select trucks, you'll probably need to slide the engine much further forward to get it out - requiring that any impediments such as radiators, A/C condensers, header. In some transmissions, the lower gears in the transmission, which touch the pool of fluid at the bottom of the transmission, transfers fluid through contact to the upper gears. In this situation, since the output to the drive axles is still attached to the gears, even when the transmission is in neutral, the fluid still flows.

Master. 2, Answers. Re: How do i replace a front wheel drive transmission? You had better get a manual as it involves removing final drive components, ie drive axles, tie rod ends, splitting ball joints, the trans drops out from under the vehicle, you may have to drop part of the frame, support the engine, removing anything over the trans, give yourself a couple of days if you have never done this. Remove the nut and slide the axle out the back of the hub. Use a length of rope or wire to support the axle while you remove the inner end. Some vehicles use bolts or clips to secure the inner axle, while others can be just pulled free with a slide hammer. Place a drain pan under transmission/differential to catch any fluid that might leak out. REMOVAL 1. REMOVE MANUAL TRANSAXLE ASSEMBLY 2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY (a) Remove the clutch release fork with the clutch release bearing from the manual transaxle. 3. REMOVE CLUTCH RELEASE FORK BOOT 4. REMOVE CLUTCH RELEASE BEARING ASSEMBLY (a) Remove the clutch release bearing from the clutch release fork. 5. REMOVE RELEASE BEARING HUB CLIP 6.