Fg1625sn manual

 · The Honeywell FGSN is a wired glass break detection sensor designed for use with Honeywell V-Plex Polling Loop Panels. As a V-Plex device, the Honeywell FGSN can only be used with compatible panels on the polling loop. It will not work if wired in as a conventional sensor. When set up properly, the FGSN works great as a glass break sensor.5/5(1). 3. Switch the FG to ACTIVATE and MANual modes. 4. Point the front of the glassbreak simulator towards the detector. Press the red START button to send a short activation code. When the detector enters Test Mode, the green LED on the detector flashes about once per second. If the green LED does not flash, move closer to the detector and. FGSN glassbreak detectors are specifically designed to allow a fast, easy installation by utilizing V-Plex® polling loop technology. Four adjustable sensitivity settings can compensate for the acoustics of any room. Optimum operation can be quickly verified using the FG glassbreak simulator. This device is designed for use only with Missing: manual.

Title: FGF Glassbreak Detector Data sheet Keywords: FGF, Flushmount Glassbreak Detector, Data Sheet Created Date: 11/18/ PM. FGSN Glassbreak EX Eight-zone V-Plex Expander and SN Serialized Eight-zone Remote Point Module Strobe Light Horn Wireless Receiver Console Relay Module Phone Line to Central Station GSMV iGSMV or Notification Appliances Keyswitch Option Series Smoke Detectors V-Plex Loop Serial Printer PC Connection. Manual Pull Stations • FGSN Seismic Detectors • SC • SC Commercial Wireless Devices • W3/W3A - Photoelectric Smoke/Heat Detector • W3 - Photoelectric Smoke Detector • - Wireless Heat Detector • CB - Wirele ss Commercial.

Page 1 ® FlexGuard FGSN V-Plex Glassbreak Detector Installation Instructions Refer to Supplemental Information (next page) for complete descriptions of these installation steps FGSN V-Plex Glassbreak Detector Enable Wall Tamper • Remove plastic tab from rear of detector. • Install wall tamper screw as shown. 2. Switch the FG to ACTIVATE and MANual modes. 3. Point the front [speaker] of the glassbreak simulator towards the detector. Press the red START button to send a short activation code. When the detector enters Test Mode, the green LED on the detector flashes about once per second. If the green LED does not flash, move closer to the detector. 3. Close the front cover. The detector’s green LED blinks approximately once per second to indicate that it has entered Test Mode. To enter the Test Mode with the FG 1. Stand within m (15 feet) of the detector. 2. Switch the FG to ACTIVATE and MANual modes. 3. Point the front [speaker] of the glassbreak simulator towards the.